Page 415 - Iscar
P. 415
LNKX/LNMT 1106 S W
Tangentially Clamped Inserts
with a Very Positive Chipformer l
and Reinforced Cutting Edge ap
r
Recommended
Dimensions Tough 1 Hard
Machining Data MILLING INSERTS
IC328 IC928 IC950 IC808 IC908 IC910 DT7150 IC4100 ap fz
Designation W l S r ap (1) (mm) (mm/t)
LNKX 1106PN-N MM 6.00 11.16 11.00 0.80 5.00 • • • • • • 1.50-5.00 0.15-0.20
LNKX 1106PNTN MM 6.00 11.16 11.00 0.80 5.00 • • • 1.50-5.00 0.17-0.25
LNMT 1106PN-N MM 6.00 11.16 11.00 0.80 5.00 • • • • • • • 1.50-5.00 0.17-0.25
• Molded chipformer to produce positive cutting • Reduced cutting forces enable higher feed capability • LNKX... is peripherally ground for accuracy and
improved surface finish • LNMT... is an economical utility insert • LNKX1106PNTN MM insert has a reinforced chamfered land • 4 R.H. and 4 L.H. cutting edges
when used on F90LN... cutters • For cutting speed recommendations, see pages 462-498
(1) DOC when the insert is on the cutter
For tools, see pages: F86LNX-11 (187) • F90LN-FR CA11 (336) • F90LN-N11 (172) • FDN-CALN11 (299) • SDN-CALN11 (307)
PN-N-MM PNTN MM
S W
LNHT 1106 PN-R HT
Tangentially Clamped Inserts with 4 l 10° Ref.
Straight Right-Hand Cutting Edges ap
r
r
Recommended
Dimensions Tough 1 Hard
Machining Data
IC928 IC908 IC910 ap fz
Designation W l S r ap (1) (mm) (mm/t)
LNHT 1106PN-R HT 5.97 11.16 11.00 0.80 10.00 • • • 2.00-7.00 0.15-0.25
• Right-hand insert with 4 cutting edges • Can machine a 90° shoulder according to the table below • For cutting speed recommendations, see pages 462-498
(1) ap max=10 mm for cast iron applications (for each pass), ap max=8 mm for steel applications
For tools, see pages: F90LN-FR CA11 (336) • F90LN-N11 (172) • FDN-CALN11 (299) • SDN-CALN11 (307)
Mismatch as a function ΔW
of cutting diameter LNHT 11..
Δh=8
Dtool ΔW
40 0.12
50 0.06
63 0.03 8
80 0.04
100 0.01
125 0.02
411