Page 440 - Iscar
P. 440
MILLING INSERTS Dimensions di OFCT 07T3-RW-16 di OFCT 07T3-AER IC908 S IC910 ap Machining Data
OFCR/OFCT-RW/AER (wiper)
Octagonal Milling Inserts with
Four Wiper Cutting Edges
r
r
F
F
OFCR 07T3-RW-P
Recommended
Tough 1 Hard
IC328
IC28
fz
F
Designation
di
S
r
(mm/t)
(mm)
OFCT 07T3-RW-16
18.35
7.00
4.60
0.60
0.50-1.00
18.45
6.80
0.10-0.15
OFCR 07T3-RW-P
OFCT 07T3-AER
0.10-0.15
18.90
1.60
0.50-1.00
5.30
7.20
• For cutting speed recommendations, see pages 462-498 4.50 0.80 • • • • 0.50-1.00 0.10-0.15
For tools, see pages: HOF-R07 (190)
A single wiper insert mounted on the HOF D..R07 cutter does the required job. The wiper insert
protrudes less than 0.1 mm axially. Wiper inserts have only 4 cutting edges. There are 4 marks
engraved on the wiper inserts. Pay attention when mounting the insert in the pocket that the marked
cutting edges are parallel to the bottom of the cutter (see sketch).
Maximum depth of cut when using the wiper insert is 2.5 mm. It is recommended to use wiper
inserts in ap=0.5-1.0 mm to achieve the best results. The criterion for indexing the wiper insert
should be the decreased quallity of the surface finish.
Recommended machining conditions for finishing operations:
Vc (finishing)= Vc (roughing) x 1.25 m/min fz=0.10-0.15 mm/t
OFMW-FF 6 5 4
Inserts with 8 FEEDMILL Large 7 3 di
Radii Segmented Cutting Edges for 8 1 2
Fast Feed on HELIOCTO Cutters
ap max S
Dimensions Tough 1 Hard Recommended Machining Data
IC928 IC908 IC910 ap fz
Designation ap di S (mm) (mm/t)
OFMW 0706R10-FF 2.20 20.40 8.00 • • • 1.00-2.20 0.40-1.50
• To be used without a seat • For cutting speed recommendations, see pages 462-498
For tools, see pages: HOF-R07 (190)
ap (mm)
2.5
2.0 D≥80 mm
1.5
1.0
0.5 D≤63 mm
0
0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 fz (mm/tooth)
436 ISCAR