Page 424 - Iscar
P. 424
LNAT 1506-PM l S W
MILLING INSERTS Dimensions r Tough 1 Hard Recommended
Tangentially Clamped Inserts with 4
Cutting Edges for Slotting Cutters
Machining Data
IC810
IC808
IC830
fz
r
l
W
S
Designation
(mm/t)
LNAT 150608-N-MM-PM
•
15.30
0.80
LNAT 150608-TN-PM
0.10-0.25
6.00
15.00
•
6.00
15.00
15.30
LNAT 150616-TN-PM
0.10-0.25
1.60
•
•
2.50
6.00
15.00
15.30
LNAT 150625-TN-PM 6.00 15.00 15.30 0.80 • • • 0.10-0.25
0.10-0.25
LNAT 150640-TN-PM 6.00 15.00 15.30 4.00 • 0.10-0.25
• For cutting speed recommendations, see pages 462-498
For tools, see pages: FDN-CAPM15 (300) • SDN-CAPM15 (308)
S
LNKX 150608AN-N PL l W
Tangentially Clamped Inserts with a
Positive Rake Angle for Cast Iron
ap
2.0 r
Recommended
Dimensions Tough 1 Hard Machining Data
IC328 IC908 IC910 DT7150 ap fz
Designation W l S r ap (1) (mm) (mm/t)
LNKX 150608AN-N PL 6.00 15.30 12.90 0.80 7.50 • • • • 2.00-7.00 0.10-0.20
• Positive land (PL) leaves sharp edges without chipping on cast iron components • High shear rake for light machining of steel, stainless steel and cast iron
• For cutting speed recommendations, see pages 462-498
(1) D.O.C when the insert is on the cutter.
S
LNKX/LNMT 150608ANTN l W
MM
Tangentially Clamped Inserts ap
with a Negative Land and
Reinforced Chipformer for 2.0 r
Unfavorable Cutting Conditions
Recommended
Dimensions Tough 1 Hard Machining Data
IC328 IC928 IC950 IC908 IC910 DT7150 IC4100 ap fz
Designation W l S r ap (1) (mm) (mm/t)
LNKX 150608ANTN MM 6.00 15.30 12.90 0.80 7.50 • • • • • • 2.00-7.00 0.30-0.40
LNMT 150608ANTN MM 6.00 15.30 12.90 0.80 7.50 • • • • • • 2.00-7.00 0.30-0.40
• Molded chipformer with reinforced negative land for unfavorable cutting conditions • Enables higher feed rates
• 4 R.H. and 4 L.H. cutting edges when used on F45LN... cutters • For cutting speed recommendations, see pages 462-498
(1) D.O.C when the insert is on the cutter
420 ISCAR