Page 841 - Iscar
P. 841
INTRODUCTION
INTRODUCTION
Balanceable Tooling System
Start TOOLING SYSTEMS
Set all 3 rings
to “0-0-0” position
Run a test
Rotate both balancing rings to the
same unbalance gr x mm and to
unbalance orientation angle
Run a test
Examples:
YES
In
tolerance
80
30 20 10 0 -10
NO
-10 0 10 20 30
Increase the original value of Up to
gr x mm of each balancing ring according 3 gr x mm
to the reading on the machine without at ±20º
changing the original angle position
10 gr x mm at 100º
NO
280
Decrease the original value of
gr x mm of each balancing Up to 50 40 30 20 10
ring according to the reading of 3 gr x mm
the machine without changing at ~180º 0 10 20 30 40
the original angle position
NO End
27 gr x mm at 285º
Less than
Rotate both balancing rings 1 gr x mm
about 5º to the indicated direction between
20º-90º
For toolholders, see pages 850, 865, 866, 897, 899
Note: The values on the balancing rings are indicated in metric values. Therefore all guidance examples for balancing are in
the metric system.
837
837
