Page 447 - Iscar
P. 447
XNMU 13
Square Inserts with 4 Right- and
4 Left-Hand Cutting Edges
r l S
Recommended
Dimensions Tough 1 Hard
Machining Data MILLING INSERTS
IC330 IC845 IC830 IC5400 IC380 IC808 IC810 IC5100 fz
Designation l S r (mm/t)
XNMU 130608PNN-MM 13.00 8.50 0.80 • • • • • 0.08-0.20
XNMU 130608PNN-PL 13.00 8.80 0.80 • 0.08-0.20
XNMU 130608PNTN 13.00 8.80 0.80 • • 0.08-0.20
• For cutting speed recommendations, see pages 462-498
For tools, see pages: ETS-XN13 (291) • FDN-XN13 (299) • SDN-XN13 (307)
di S
ONHU/ONMU-08-TN/HL
Octagonal Double-Sided Face
Milling Inserts for Cast Iron
and Rough Applications 45°
r ap
Dimensions Tough 1 Hard Recommended
Machining Data
IC908 IC810 IC910 DT7150 IC5100 IC4100 ap fz
Designation di r S ap (mm) (mm/t)(1)
ONHU 080608-TN 20.20 0.80 6.00 5.50 • • • 2.00-5.50 0.20-0.30
ONMU 080608-TN 20.20 0.80 6.00 5.50 • • • • • 2.00-5.50 0.20-0.30
ONMU 080612-HL 20.20 1.20 6.00 5.50 • • 2.00-5.50 0.25-0.40
• TN - For cast iron • HL - For rough applications and inhomogeneous surfaces • For cutting speed recommendations, see pages 462-498
(1) For FEEDMILL tools, see the feed conditions for the FF NM tools
For tools, see pages: F45NM (192) • F45WG (192) • FF NM (264)
TN HL
di S
ONHU/ONMU-08-TN-MM
Octagonal Double-Sided Face Milling
Inserts for General Steel Machining
45°
r ap
Recommended
Dimensions Tough 1 Hard Machining Data
fz
IC330 IC328 IC830 IC928 IC5400 IC808 IC908 IC910 ap (mm/t)
Designation di r S ap (mm) (1)
ONHU 080608-TN-MM 20.20 0.80 6.00 5.50 • • • • 2.00-5.50 0.20-0.30
ONMU 080608-TN-MM 20.20 0.80 6.00 5.50 • • • • • • • 2.00-5.50 0.20-0.30
• For cutting speed recommendations, see pages 462-498
(1) For FEEDMILL tools, see the feed conditions for the FF NM tools
For tools, see pages: F45NM (192) • F45WG (192) • FF NM (264)
443