Page 110 - logic

FOR INTERNAL USE ONL Y • SUBJECT TO CHANGE

Turning Grades

A hard submicron substrate. TiAlN PVD coated grade
followed by a special “SUMO TEC” surface treatment.
PM KN SH Suitable for turning hard nickel base alloys / Inconel
3 (40-50 HRC) at low to medium cutting speeds.

A tough submicron substrate, TiAlN PVD coated grade
followed by a special “SUMO TEC” surface treatment.
PM KN SH Suitable for turning nickel-based high temperature alloys
3 at low to medium cutting speeds.

A tough submicron substrate, improved TiAlN PVD coated
grade for better chip flow. Suitable for turning heat
PM KN SH resistant alloys, austenitic stainless steel and hard steel at
low to medium cutting speeds.
3 3 3 3 3

A very hard substrate with a cobalt enriched outer layer and
alpha Al O coating. Used for finishing and medium turning
2
3
PM KN SH of stainless steel at high cutting speeds. Features long tool
3 life and excellent repeatability.

A tough substrate with MTCVD Al O and TiCN coating.
2
3
Recommended for machining stainless steel at high feeds
PM KN SH and unfavorable conditions at medium cutting speed.
3

A tough substrate with a cobalt enriched layer combined
with improved MTCVD TiCN and a thick alpha Al O CVD
2
3
coating. Recommended for general use machining of steel
PM KN SH in a wide range of conditions, featuring high toughness and
3 3 resistance to chipping and plastic deformation.

MACHINING IN DUSTRY 4.0
TELLIGENTLY
110