Page 706 - Iscar
P. 706

USER GUIDE
       REAMERS  Troubleshooting







                  Problem
                                                   Cause
                                                                                   Solution
                                        • Reamer or pilot hole not centered • Use a floating reamer chuck or correct pilot hole
                                        • Reamer too large         • Check size of reamer and correct if necessary
                Hole too large          • Cooling / lubrication problems  • Change lubricant and increase coolant pressure
                               dnom
                                        • Worn reamer              • Replace the reamer
                                        • Reaming allowance too small  • Increase reaming allowance
                Hole too small          • Cooling / lubrication problems  • Change lubricant and increase coolant pressure
                               dnom
                                        • Misalignment between     • Re-align or use a floating reamer chuck
                                          pre hole and reamer centers
                Conical hole
                (larger bottom)
                                dnom
                                        • Misalignment between     • Re-align or use a floating reamer chuck
                Conical hole              pre-hole and reamer centers  • Secure the tool axially
                (larger                 • Material jammed between reamer
                entrance)                 and hole in the upper hole section
                                dnom
                                        • Worn reamer              • Replace the tool
                                        • Misalignment between     • Re-align or use a floating reamer chuck
                Poor surface              pre-hole and reamer centers  • Increase coolant pressure
                finish                  • Problems with chip evacuation  • Change cutting parameters
                                        • Incorrect cutting parameters  • Change cutting parameters
                                        • Built-up edge              or coolant conditions




















































            ISCAR
   702      ISCAR
   702
   701   702   703   704   705   706   707   708   709   710   711