Page 65 - logic

FOR INTERNAL USE ONL Y • SUBJECT TO CHANGE FOR INTERNAL USE ONL Y • SUBJECT TO CHANGE

OAL
FFT3 EFM-03 A LH
Endmills Carrying Single-Sided Small Rd°
Trigon Inserts for Fast Feed Milling DCX DC DCONMS
APMX
17°
A
Designation DCX DC APMX CICT (1) LH OAL DCONMS Shank (2) RMPX (3) kg
FFT3 EFM D10-2-080-C10-03 10.00 5.60 0.60 2 20.0 80.00 10.00 C 6.9 0.11
FFT3 EFM D12-3-120-C12-03 12.00 7.60 0.60 3 25.0 120.00 12.00 C 4.7 0.14
FFT3 EFM D16-4-140-C16-03 16.00 11.60 0.60 4 35.0 140.00 16.00 C 2.9 0.18
• Radius for programming 1.1 mm
(1) Number of inserts
(2) C-Cylindrical, W-Weldon
(3) Maximum ramping angle

Spare Parts
Designation
FFT3 EFM-03 TS 18041I/HG T-6IP/51

OAL
FFT3 EFM-MM 03 LF
Endmills with a MULTI-MASTER Rd°
Threaded Adaptation Carrying DCX DC THSZMS DCONMS
Single-Sided Small Trigon
Inserts for Fast Feed Milling
DRVS

Designation DCX DC APMX CICT (1) LF DCONMS THSZMS OAL DRVS (2) RMPX (3) kg
FFT3 EFMD10/.39-2MMT06-03 10.00 5.60 0.60 2 10.00 9.70 T06 16.30 8.0 6.9 0.02
FFT3 EFMD12/.47-3MMT08-03 12.00 7.60 0.60 3 15.00 11.70 T08 22.50 10.0 4.7 0.03
FFT3 EFMD16/.63-4MMT10-03 16.00 11.60 0.60 4 20.00 15.30 T10 31.30 13.0 2.9 0.05
• Radius for programming 1.1 mm
(1) Number of inserts
(2) Key flat size
(3) Maximum ramping angle
Spare Parts

Designation
FFT3 EFM-MM 03 TS 18041I/HG T-6IP/51

S
FFT3 WXMT 03 IC
Single-Sided Small Trigon Rd°
Inserts for Fast Feed Milling
RE 17˚
APMX
Recommended
Dimensions Tough 1 Hard
Machining Data
IC830 IC808 ap fz
Designation IC S RE APMX (mm) (mm/t)
FFT3 WXMT 030206T 4.20 2.20 0.60 0.60 • • 0.20-0.60 0.20-0.80

65