Page 887 - Iscar

INTRODUCTION

CAMFIX Chucking Instructions diameter of the shank is smaller than the CAMFIX
Please be careful when clamping cylindrical shank through hole, it may penetrate into the drawbar
cutting tools into CAMFIX holders such as ER mechanism area and prevent proper clamping. CAMFIX DIN 26623-1
collet chucks or EM holders. In cases when the

Preset screw Locking jaws are not
located correctly

Face contact Locking jaws No face contact
✔ ✘

Correct clamping Wrong clamping
Use a preset screw to prevent the cutter shank from The cutter shank enters into the locking mechanism
entering into the clamping mechanism zone, so the zone, preventing the drawbar locking jaws to
drawbar locking jaws can function correctly. reach their correct clamping position.

In order to prevent too deep insertion of the
cutting tools, the short length ER16, 20, 25, 32,
40 collet chucks and EM 6-50 mm endmill holders
are equipped with permanent stoppers.

Stopper washer

ER chucks
A special washer is installed as a permanent stopper.

883